Dry floor grid ± 10 m²

Delivery Information

- Click here for all information regarding home delivery and delivery times.

- Click here for all information regarding pickup in Olsene (East Flanders, Belgium).

Product Information

- Exclusively designed for Staenis dry floors.

- All product information can be found at www.staenis.com.

Product is developed and produced in Belgium.

Application

- With these green, fiber-reinforced slats and legs, you don't need to place 8 extra leveling legs per square meter when using a non-load-bearing filler in the leveling grid.

- The 5 leveling legs must be glued to the subfloor with PU foam to prevent them from turning later due to vibrations.

- You still need to double board with non-load bearing fillers. For load-bearing fillers, you should use at least a 22 mm thick OSB board. With these fiber-reinforced slats, your floor will feel much sturdier with a single 22 mm thick OSB. However, keep in mind that double boarding yields better results.

Required Quantity

- Box contains 80 (fiber-reinforced) slats + 50 legs for approximately 10 m² (square meter estimate is indicative).
Note: The exact number of m² varies from room to room, so always plan for a bit extra, especially for smaller areas and surfaces with edges and corners or requiring more finishing work against walls (such as in hallways). Perhaps first make a sketch with an estimate of the grid placement.

- Use our quantity calculator for easier calculations.

Specifications

- Height adjustment possible from 4.5 cm to 9 cm. Use the yellow screed extension legs to adjust up to 13 cm in height without loss of load-bearing capacity.
- These fiber-reinforced slats are 2.5 times stronger than the standard black slats.
- The fiber-reinforced legs can withstand a high point load of 300 kg (the yellow screed legs 150 kg).

Downloads

- Information brochure